• Accessories
  • Details
  • Specifications
  • Documents
  • Manufacturer: Saniflo
  • Item SKU: 021
  • Finish: White
  • Collection: Saniswift
  • Saniswift Residential Water Pump

    The Saniswift is a gray water pump that is ideally suitable for use in a

    basement apartment or anywhere in the house where additional fixtures

    are most wanted. It will pump the waste water away from a variety of

    sources such as: a kitchen sink, laundry sink, washing machine

    (indirect connection), dishwasher, bar sink, etc.

    The Saniswift's modern style prevails over other bulky relics. This

    system offers powerful and economical pumping action in a compact,

    contemporary design. With unprecedented performance and features,

    this pump is unmatched in its class.

    The inside of the Saniswift comprises of a pressure switch and circuit

    board assembly, which starts and stops the unit, and the motor, which

    drives the pump.

    When the water enters the Saniswift, it activates a pressure switch

    which in turn starts the motor. The motor is sealed for life in an oil filled

    enclosure. A spindle/shaft drives the impeller and therefore the moving

    parts are kept to an absolute minimum.

    The unit pumps the effluent upward to 14 feet and/or 140 feet horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the pressure switch deactivates the unit until water enters the unit again. A normal operating cycle for the Saniswift can be as short as 2 - 10 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.

    In addition to a sink, the Saniswift will also accept and discharge the waste water from a variety of other sanitary fixtures such as: a kitchen sink, a shower, a urinal. When adding a shower, a base will have to be constructed.

    This base should be made out of a 2" x 6" (minimum) or 2" x 8" (recommended) on edge, to allow for the installation of a P-trap and the required 1/4" per foot gravity flow towards the pump unit.

    The waste water from other sanitary fixtures is discharged into the Saniswift via two 1-1/2 inch inlets, on either side of the housing and an additional inlet on the top of the unit. A non-return valve, which comes already assembled on the discharge rubber connector, prevents back flow into the unit.

    This unit has been designed with a vent connection on the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent.

    It is also highly recommended for the gray water pump to be connected to a Ground Fault Interrupter (GFI) circuit.

    The Saniswift is a compact unit with attractive rounded contours that fits neatly into tight spaces.
Motor: Induction Motor
Motor RPM: 3600
Horsepower: 0.3
Electrical Supply: 110-115V; 60Hz
Flow rate at max head USG / MIN: 14 ft:18gal/min;3ft: 24gal/min
Amperage: 5.9
Discharge Pipe Diameter: 1" diameter
Vertical Discharge: 14 ft
Horizontal Discharge: 140 ft
Gravity fall on horizontal installations: 1/4" per ft
Normal Running Time WC: 2-10 seconds
Maximum Temperature: 140 degreeF
Dimensions (measured from floor level): H8-3/4" x W9" x D101/4"
Materials: Polypropylene, C.R.P., stainless steel, Neoprene
  • Manufacturer: Saniflo
  • Item SKU: 021
  • Finish: White
  • Collection: Saniswift

Decor Island Is Your #1 Choice.