This Saniflo Sanicubic Classic includes:
Grinding Unit: Model# 029

Manufacturer: Saniflo
Item SKU: 029
Finish: Gray
Collection: Sanicubic Classic

The Sanicubic Classic is a pre-assembled heavy-duty grinder pump that meets

the demanding needs of commercial and residential sewage applications. The

two-grinder system made of stainless steel liquefies solids into small particles

prior to being passed through the 1-1/2" discharge. It is designed to handle

multiple waste fixtures for applications such as residential single or group

homes, commercial buildings, schools and many more.


This new system consists of two 1-horsepower motors housed inside a compact but

highly durable plastic enclosure. Each independently operating grinder has its

own high-performance grinding system: a fast-rotating cutting blade to reduce

solids in the wastewater stream from toilets, tubs and showers, sinks, washing

machines, dishwashers, etc.





The Sanicubic Classic operation is as simple as the installation. The effluent

enters the pump through one of five different inlets - one on either side of the

unit at the bottom and three along the top. The inlets can accommodate 1-1/2" or

4" diameter pipes. As soon as the wastewater level reaches the trigger point,

the pumping system activates. The effluent is then pumped out through 1-1/2"

diameter rigid pipe connected on the top of the pump. Maximum pumping distances

are 36 Ft vertically and/or 328 Ft horizontally.


The inside of the Sanicubic Classic comprises of a couple of pressure switches

and a circuit board assembly, which starts and stops the unit, and of a couple

of motors, which drive the stainless steel cutting blades and the pump. Water

and organic waste matter that enter the enclosure are reduced to slurry and are

picked up by the impeller mounted beneath the motor.


The two grinders inside the Sanicubic Classic are engineered to operate

alternately. They each take turns handling the wastewater so that neither is

more heavily used over time than the other. However, if either pump ceases to

operate, the other pump will run full-time until servicing can eliminate the

problem.


One of the many features of the Sanicubic Classic, is the smart-pump operation.

A single pump is able to handle up to 50 gpm. If the incoming rate is higher

than the discharge rate, the pump automatically signals the "overload" stage.

This will activate the second pump and both pumps will operate simultaneously

until the condition is alleviated. When both pumps are in operation, the

discharge rate increases roughly 80%. In this event, a visual alarm LED on the

unit will switch to red.





The wastewater from other sanitary fixtures is discharged into the Sanicubic

Classic via five 11/2-inch or 4" inlets, on either side of the housing and on the

top of the enclosure. The internal discharge pipes come equipped with check

valves that prevent back flow into the unit. Isolating valves (not supplied)

must be installed on waste inlets and on the discharge pipe to ensure that any

service/maintenance may be carried out safely.


This unit has been designed with a 1-1/2" vent connection on the top of the

enclosure. All plumbing codes require connection to a vent system. Please note

that the vent system should be a two-way air vent. The use of mechanical vents,

air admittance valves or similar devices are not permitted as these are

considered one-way air vent systems.





The Sanicubic Classic has been certified to American and Canadian Standards. US:

CSA Certified & IAPMO (UPC) listed - ASME A112.3.4, CA: Macerating Standard CSA

B45.9.

Manufacturer: Saniflo
Item SKU: 029
Finish: Gray
Collection: Sanicubic Classic